Outils pratiques pour un travail de précision
Calculateur de Cote de Raccord & Longueur de Coupe
Déduisez les cotes centre-extrémité des raccords, saisies par l'utilisateur, des mesures de terrain pour trouver une longueur de coupe de tuyau.
Calculez la disposition, vérifiez le diagramme, puis imprimez le résultat pour l'atelier ou le chantier.
Actual center-to-end dimension from your fitting data.
Used for center-to-center measurements only.
Add positive for insertion/makeup allowance; negative for a root gap or trim deduction.
Cut = entered span − applicable fitting takeoff(s) + net fabrication allowance. Verify the takeoffs against the exact fittings and joining method in hand.
How it works
Use actual fitting dimensions. Measure the target span, choose where that measurement starts and ends, then enter each fitting's center-to-end takeoff. Center-to-center deducts both fittings; center-to-end deducts fitting A; end-to-end deducts neither.
Example. A 1,200 mm center-to-center spool with two 76 mm elbows needs 1,200 − 76 − 76 = 1,048 mm of straight pipe before any joining allowance.
Current-input example
The result above uses these exact values. This snapshot is included when the page is printed so the output can be checked against the original measurements.
- Measured assembly length
- 1200 mm
- Measurement reference
- Fitting center to fitting center
- Fitting A takeoff
- 76 mm
- Fitting B takeoff
- 76 mm
- Net fabrication allowance
- 0 mm
Primary result: Straight pipe cut: 1048.0 mm.
Before using the result
- Measure from the datum or reference edge described by this tool, and do not mix inside, outside and centerline dimensions.
- Keep inputs in the displayed units and preserve more precision than the final cutting or purchasing tolerance requires.
- When the result is close to a limit, verify it with a test piece, field measurement, manufacturer drawing or qualified project professional.
Limitations
This is standard-neutral cut arithmetic, not a fitting database. Takeoffs change with nominal size, schedule, radius, end preparation, manufacturer, socket depth, thread engagement and weld gap. Confirm those values before cutting.
Frequently asked questions
Why is the allowance signed?
Different joining methods require different treatment. A positive number lengthens the raw cut for insertion or makeup; a negative number shortens it for a specified gap or later trim.
Outils associés
Positionnement Horaire
Convertissez des décalages vertical et latéral en positions horaires aux extrémités proche/éloignée et en repères de circonférence à partir d'un datum établi.
Multiplicateur de Décalage
Calculez la course et le parcours d'un décalage de tuyau dans le même plan à partir de la distance de décalage et de l'angle du raccord, avec le tableau de multiplicateurs standard.
Gabarit Encoche Tube
Générez un gabarit grandeur nature en gueule-de-poisson ou en selle pour l'intersection théorique entre deux tubes.
Calculateur Tolérance de Pliage
Calculez la tolérance de pliage, la déduction de pliage et le retrait pour un pli de tôle, avec un schéma.