Herramientas prácticas para trabajos de precisión
Calculadora de Pila de Bloques Patrón para Regla de Senos
Calcule la altura de la regla de senos y encuentre una combinación corta de bloques patrón métricos cercana al objetivo.
Suggested blocks come from a representative metric set. Confirm every size exists in your own set and use calibrated deviations for precision work.
How it works
How to use it: enter the certified roller-centre distance and target angle. The tool calculates height, then searches a representative metric gauge-block set for a short stack near that height.
Formula. Stack height = sine bar length x sin(angle). The combination search works in one-micron increments and reports residual height and achieved angle.
Example. A 100 mm sine bar at 30 degrees needs a nominal 50.000 mm stack.
Current-input example
The result above uses these exact values. This snapshot is included when the page is printed so the output can be checked against the original measurements.
- Sine bar roller-centre distance
- 100 mm
- Target angle
- 30 deg
- Maximum blocks in stack
- 4
Primary result: Target height: 50.0000 mm.
Before using the result
- Measure from the datum or reference edge described by this tool, and do not mix inside, outside and centerline dimensions.
- Keep inputs in the displayed units and preserve more precision than the final cutting or purchasing tolerance requires.
- When the result is close to a limit, verify it with a test piece, field measurement, manufacturer drawing or qualified project professional.
Limitations
This is a nominal planning aid, not a calibration certificate. Verify available block sizes, individual calibration corrections, wringing condition, temperature, cleanliness, bar calibration and setup direction. Never force an unstable stack.
Frequently asked questions
Why limit the block count?
Shorter stacks are generally easier to wring and handle. Increase the limit only if your set cannot make a close combination.
Herramientas relacionadas
Calculadora de Avellanado
Resuelva la profundidad, el diámetro mayor, el diámetro piloto o el ángulo incluido del avellanado con una vista de sección en vivo.
Transportador Imprimible
Prepare un transportador de 180° a tamaño real y verifique su marca de calibración impresa antes de usarlo.
Plantilla de Muescado
Genere una plantilla a tamaño real en boca de pez (fishmouth) o silla de montar para la intersección teórica entre dos tubos.
Plantilla de Círculo de Pernos
Ingrese el diámetro del círculo de pernos y la cantidad de agujeros para generar una plantilla imprimible a tamaño real con verificación de calibración.