Herramientas prácticas para trabajos de precisión
Calculadora de Descuento de Accesorios y Longitud de Corte de Tubería
Reste las dimensiones de centro a extremo de los accesorios (takeoff), suministradas por el usuario, de las medidas de campo para hallar la longitud de corte de tubería.
Calcule el diseño, revise el diagrama y luego imprima el resultado para el taller o la obra.
Actual center-to-end dimension from your fitting data.
Used for center-to-center measurements only.
Add positive for insertion/makeup allowance; negative for a root gap or trim deduction.
Cut = entered span − applicable fitting takeoff(s) + net fabrication allowance. Verify the takeoffs against the exact fittings and joining method in hand.
How it works
Use actual fitting dimensions. Measure the target span, choose where that measurement starts and ends, then enter each fitting's center-to-end takeoff. Center-to-center deducts both fittings; center-to-end deducts fitting A; end-to-end deducts neither.
Example. A 1,200 mm center-to-center spool with two 76 mm elbows needs 1,200 − 76 − 76 = 1,048 mm of straight pipe before any joining allowance.
Current-input example
The result above uses these exact values. This snapshot is included when the page is printed so the output can be checked against the original measurements.
- Measured assembly length
- 1200 mm
- Measurement reference
- Fitting center to fitting center
- Fitting A takeoff
- 76 mm
- Fitting B takeoff
- 76 mm
- Net fabrication allowance
- 0 mm
Primary result: Straight pipe cut: 1048.0 mm.
Before using the result
- Measure from the datum or reference edge described by this tool, and do not mix inside, outside and centerline dimensions.
- Keep inputs in the displayed units and preserve more precision than the final cutting or purchasing tolerance requires.
- When the result is close to a limit, verify it with a test piece, field measurement, manufacturer drawing or qualified project professional.
Limitations
This is standard-neutral cut arithmetic, not a fitting database. Takeoffs change with nominal size, schedule, radius, end preparation, manufacturer, socket depth, thread engagement and weld gap. Confirm those values before cutting.
Frequently asked questions
Why is the allowance signed?
Different joining methods require different treatment. A positive number lengthens the raw cut for insertion or makeup; a negative number shortens it for a specified gap or later trim.
Herramientas relacionadas
Reloj de Desvío de Tubería
Convierta los desvíos vertical y lateral en posiciones de reloj para el extremo cercano/lejano y marcas de circunferencia a partir de un datum establecido.
Multiplicador de Desvío
Calcule el recorrido (travel) y el tramo (run) de un desvío de tubería en el mismo plano, a partir de la distancia de desvío y el ángulo del accesorio, con la tabla estándar de multiplicadores.
Plantilla de Muescado
Genere una plantilla a tamaño real en boca de pez (fishmouth) o silla de montar para la intersección teórica entre dos tubos.
Calculadora de Tolerancia de Plegado
Calcule la tolerancia de plegado, la deducción de plegado y el retroceso (setback) para un pliegue en chapa metálica, con un diagrama.