Rechner für Rohrversatz-Uhrposition & Rotation

This is clocking, not another travel calculator. Rise and signed lateral displacement define the offset plane. Its rotation from 12 o'clock is atan2(lateral, rise), then the entered datum is added and normalized to 0–360°.

The wrap mark converts that clock angle into tape distance around the actual OD: circumference × angle ÷ 360. Because a fabricator looking back from the far end sees clockwise direction mirrored, the far-end reading is 360° − the near-end reading.

The result above uses these exact values. This snapshot is included when the page is printed so the output can be checked against the original measurements.

Vertical offset (+ up)

300 mm

Lateral offset (+ right)

400 mm

Actual pipe outside diameter

168.3 mm

Top datum clock angle

0 deg

Primary result: Near-end clock: 53.1 deg.

• Measure from the datum or reference edge described by this tool, and do not mix inside, outside and centerline dimensions.
• Keep inputs in the displayed units and preserve more precision than the final cutting or purchasing tolerance requires.
• When the result is close to a limit, verify it with a test piece, field measurement, manufacturer drawing or qualified project professional.

This establishes orientation marks only. It does not calculate elbow travel, weld shrinkage or fitting takeoff. The far-end conversion assumes both ends share the same physical top datum and the stated viewing directions; if your drawing uses plant north, pipe direction, or a different clock convention, reconcile that convention first.